Qualcomm Robotics RB5/RB6 - Building from sources

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Why the RB5/RB6? Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Running Inception v3 Running MobileNetV2 + SSD TensorFlow Example pipeline TensorFlow to DLC Conversion
Sensors
IMU
Demos
Drone Demo Smart Camera
Contact Us

This section will guide you through the process of building your own Image using Yocto. In the first section we will cover how to create a base image and some of the available options and then we will show the steps to customize this base image.

• The Build image section explains how to build an Image using the Yocto Project.
• The Customize image section explains how to customize your Image adding the meta-ridgerun layer.