Qualcomm Robotics RB5/RB6 - Getting into the Board

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Why the RB5/RB6? Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Running Inception v3 Running MobileNetV2 + SSD TensorFlow Example pipeline TensorFlow to DLC Conversion
Sensors
IMU
Demos
Drone Demo Smart Camera
Contact Us

The Qualcomm Robotics RB5/RB6 can be accessed via the microUSB cable with UART, via USB-C cable with adb and with SSH via ethernet cable. The steps for each method are explained in the links below:

• The Using ADB section explains how to access the board with ADB.
• The Using Serial Console section explains how to access the board with UART.
• The Using SSH section explains how to access the board with SSH.