Thundercomm TurboX C8550 - HDMI Setup

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

This section will help you to enable the HDMI display in the board.

1. Make sure that SW1300 switches 1 and 2 on Figure 1 are set in the ON position. If not, power off the board and set them on the right position, then power on again.

Figure 2. SW1300 switches

2. Plug an HDMI cable between a display and the HDMI Out port from the board.

You should see now the image on your display.