Thundercomm TurboX C8550 - Debug Modes

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

The Thundercomm TurboX C8550 has two modes that allow putting the board on recovery and flash it. The following sections will show you the process on how to setup your board in these modes if needed.

• The 9008 Mode section is a guide to setup your board in 9008 Mode.
• The Fastboot Mode section is a guide to setup your board in Fastboot Mode.