Thundercomm TurboX C8550 - Thundercomm SDK

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

The Thundercomm SDK Manager is the official tool to work with Thundercomm TurboX C8550. It provides an end-to-end image generation solution for developers to work with TurboX C8550 devices. In this section, you will learn how to get started with Thundercomm SDK Manager, this will allow you to create OS images for your board and flash it. The following sections will provide information about what is included in the SDK, a description of its components, and how to use them to get your Thundercomm TurboX C8550 up and running.

• The Installing SDK Manager section covers how to download and install the SDK Manager in the host computer.
• The Configuring SDK Manager section covers how to configure the SDK Manager and have it set up and ready to use.
• The Downloading Prebuilt Images section covers the steps to download a prebuilt LE (Linux Embedded) image.
• The Building Images from Source section covers the steps to build a LE (Linux Embedded) image from source.
• The Flashing the Images section covers the steps to flash a LE (Linux Embedded) image to the TurboX C8550 Developer Kit.