Thundercomm TurboX C8550 - Boot Devices

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

The boot device is the memory component from where the bootloader and the operating system keep the necessary files to successfully boot the device. The boot order is a configuration that is used by the PBL (Primary Boot Loader) firmware, which is the first software to load after powering up the platform, to search in the boot devices, in the determined order, and load the bootloader, from the device it was found, into main memory. The Thundercomm TurboX C8550 Developer kit has the following boot devices:

• UFS (Universal Flash Storage): This device is the 128GB Flash memory located in the QCS8550 SoM.