Thundercomm TurboX C8550 - Getting into the Board

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

The Thundercomm TurboX C8550 can be accessed via the microUSB cable with UART, via USB-C cable with adb and with SSH via ethernet cable. The steps for each method are explained in the links below:

• The Using ADB section explains how to access the board with ADB.
• The Using Serial Console section explains how to access the board with UART.
• The Using SSH section explains how to access the board with SSH.