Thundercomm TurboX C8550 - Development in the Board

Thundercomm TurboX C8550
Introduction
SoM Overview Why the TurboX C8550? Carrier Boards Thundercomm TurboX C8550 Developer Kit
Software Development Support
Boot Devices Thundercomm SDK Installing SDK Manager Configuring SDK Manager Downloading Prebuilt Images Building Images from Source Flashing the Images Special / Debug Modes Setting up Board in 9008 Mode Setting up Board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup Ethernet Setup WiFi Setup HDMI Setup Camera Setup
Intelligent SDK
QIM SDK TFLite SDK
GStreamer Pipelines
Contact Us

This section will help you to start on the process of developing on the board once it has been flashed with an image. You will be guided on how to get into the board and how to setup initial device configurations:

• The Getting into the Board section explains three ways to access the board.
• The Device Setup section explains some initial configurations to ease your development process in the board.