Thundercomm TurboX C8550 - Debug Modes

From RidgeRun Developer Wiki
< Thundercomm TurboX C8550‎ | Software Support
Revision as of 18:16, 10 December 2024 by Spalli (talk | contribs) (Created page with "<noinclude> {{Thundercomm TurboX C8550/Head|previous=Software_Support/SDK/Flashing_the_Images|next=Software_Support/Debug_modes/Set_up_9008_Mode|description=}} </noinclude> {{DISPLAYTITLE:Thundercomm TurboX C8550 - Debug Modes|noerror}} The Thundercomm TurboX C8550 has two modes that allow putting the board on recovery and flash it. The following sections will show you the process on how to setup your board in these modes if needed. <br> *The Thundercomm TurboX C855...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


⇐ Index ⇒


Thundercomm TurboX C8550
Introduction
SoM Overview
Why the TurboX C8550?
Carrier Boards
Software Development Support
Boot Devices
Thundercomm SDK
Special / Debug Modes
Development in the Board
Getting into the Board
Device Setup
Intelligent SDK
QIM SDK
TFLite SDK
GStreamer Pipelines
Contact Us





The Thundercomm TurboX C8550 has two modes that allow putting the board on recovery and flash it. The following sections will show you the process on how to setup your board in these modes if needed.

  • The 9008 Mode section is a guide to setup your board in 9008 Mode.
  • The Fastboot Mode section is a guide to setup your board in Fastboot Mode.


⇐ Index ⇒



Retrieved from "https://developer.ridgerun.com/wiki/index.php?title=Thundercomm_TurboX_C8550/Software_Support/Debug_modes&oldid=62965"