NVIDIA Jetson Orin/Introduction/Carrier Boards/Auvidea X230D: Difference between revisions
(Created page with "<noinclude> {{NVIDIA Jetson Orin/Head|previous=Introduction/Carrier Boards/Nvidia developer kit|next=Introduction/Software Support|keywords=carrier,carrier board,base board,co...") |
No edit summary |
||
Line 1: | Line 1: | ||
<noinclude> | <noinclude> | ||
{{NVIDIA Jetson Orin/Head|previous=Introduction/Carrier Boards/Nvidia developer kit|next=Introduction/ | {{NVIDIA Jetson Orin/Head|previous=Introduction/Carrier Boards/Nvidia developer kit|next=Introduction/Carrier_Boards/Connect Tech Forge|keywords=carrier,carrier board,base board,auvidea}} | ||
</noinclude> | </noinclude> | ||
<!-- If you want a custom title for the page, un-comment and edit this line: | <!-- If you want a custom title for the page, un-comment and edit this line: |
Revision as of 13:14, 1 August 2022
Forge is Connect Tech’s first full-featured Carrier Board for the NVIDIA® Jetson AGX Orin™ module. This carrier board for Jetson AGX Orin™ is specifically designed for commercially deployable platforms and has a small footprint of 155mm x 125mm.
Forge provides access to an impressive list of latest-generation interfaces on the Jetson AGX Orin while adding additional interfaces of 3x USB 3.2, 2x GbE, Display Port, and a locking 6-pin Mini-Fit Jr. power input connector.
Rugged camera add-on expansion boards will also be available for use with Forge to interface directly with high-density MIPI CSI interfaces. Figure 1 shows a picture of the Forge carrier board and Table 1 shows its specifications.
Feature | Description |
---|---|
Networking |
|
Camera Inputs | 1x DisplayPort |
Display |
|
USB | 1x USB 3.2 Ports (Type-C – OTG Capable), 1x USB 3.2 Ports (Type-C) |
Storage | 1 x Micro SD/UFS Card Slot, 2x NVMe M.2 Key M Slot |
UART |
|
I2C/SPI |
|
GPIO | 4x GPI, 4x GPO |
User Expansion |
|
Input Power | +10 to 36V DC Wide Input Power
(6-pin Mini-fit Jr. Connector) |
Buttons | Power, Reset, Recovery
(Tactile Buttons as well as fine pitch pin header connector) |
RTC Battery | 3-pin Picoblade connector to accept CTI battery cable assembly |
PCB/Electronics Mechanical Information | Dimensions: 155mm x 125mm |
Operating Temperature | -40°C to +85°C (-40°F to +185°F) |
You can get this board from the Forge Product Page