Onvif device server/Getting Started/Server Example: Difference between revisions
Efernandez (talk | contribs) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 25: | Line 25: | ||
This example will generate a video test pattern as video source that should look like the following picture. | This example will generate a video test pattern as video source that should look like the following picture. | ||
<br> | |||
<br> | |||
[[File:Pattern.jpg|800px|thumb|center]] | [[File:Pattern.jpg|800px|thumb|center]] | ||
Latest revision as of 18:41, 25 April 2024
 | Make sure you also check ONVIF device server's companion project: Onvif Device Reference Design |
| ONVIF device server |
|---|
 |
| Introduction |
| User Guide |
| Getting Started |
| Examples |
| Evaluating |
| Contact Us |
Example server implementation
With the Library you will get a Basic Server Implementation.
In order to test the application follow the next steps:
- Build and install the library.
- Make sure GStreamer Daemon is installed and running.
- Run ONVIF server with the following command:
onvif-server <net_interface>
where net_interface is the name of the network interface you will be using (e.g eth0).
After this, the server should be discoverable for ONVIF clients.
This example will generate a video test pattern as video source that should look like the following picture.
