20,290
edits
Raspberry Pi HQ camera IMX477 Linux driver for Jetson: Difference between revisions
Raspberry Pi HQ camera IMX477 Linux driver for Jetson (view source)
Revision as of 18:33, 20 October 2021
, 20 October 2021→Recovery Mode for Jetson Nano
m (→Jetson Nano) |
|||
| Line 131: | Line 131: | ||
# Remove the jumper from the Force Recovery Mode pins. | # Remove the jumper from the Force Recovery Mode pins. | ||
<br> | <br> | ||
*For the B01 carrier board, the force recovery pins are the 9 and 10 pins (FC REC and GND) of the Button Header. The B01 Button Header is located on the edge of the carrier board under the heat sink and SD card slot.<br> | {{Ambox | ||
*For the A02 carrier board, the force recovery pins are the 3 and 4 pins of the Button Header. | |type=notice | ||
|small=left | |||
|issue= | |||
*For the B01 carrier board, the force recovery pins are the 9 and 10 pins (FC REC and GND) of the Button Header. The B01 Button Header is located on the edge of the carrier board under the heat sink and SD card slot.<br> | |||
*For the A02 carrier board, the force recovery pins are the 3 and 4 pins of the Button Header. | |||
|style=width:unset; | |||
}} | |||
<br> | |||
6. When the OS has been installed successfully in the [Xavier NX | Nano], you will be asked to enter the board IP, a username and a password, as shown below in Figure7: | 6. When the OS has been installed successfully in the [Xavier NX | Nano], you will be asked to enter the board IP, a username and a password, as shown below in Figure7: | ||