Hardware Connection

From RidgeRun Developer Wiki



Previous: Architecture Index Next: Bring Up Process







Hardware Required

Here you can find a list with the hardware required

  1. NVIDIA Jetson Orin AGX
    NVIDIA Jetson Orin AGX. Source: NVIDIA
  2. NVIDIA Holoscan Sensor Bridge
    Holoscan Sensor Bridge. Source: Lattice Semiconductor
  3. Jetson-IMX274-Dual Cameras
    li-jetson-imx274-dual. Source: Leopard Imaging Inc
  4. 10Gtek Ethernet Adaptor
  5. Ethernet Cable
  6. USB A to USB C cable

    Connection Diagram

    Here you can find a diagram describing the connection required.

    Hardware Diagram Connection

    Host Set Up

    Use the following steps to set up the hardware requirements.

    1. Install git-lfs
      sudo apt-get update
      sudo apt-get install -y git-lfs
    2. Enable larger network receiver buffers.
      echo 'net.core.rmem_max = 31326208' | sudo tee /etc/sysctl.d/52-hololink-rmem_max.conf
      sudo sysctl -p /etc/sysctl.d/52-hololink-rmem_max.conf
    3. Configure a static address the IP for the eth0 port.
      sudo nmcli con add con-name hololink-eth0 ifname eth0 type ethernet ip4 192.168.0.101/24
      sudo nmcli connection up hololink-eth0
    4. Go to /boot/extlinux/extlinux.conf and add
      isolcpus=2

      At the end of the line that starts with APPEND.


      If you need more detailed information about the Hardware set up use the following Link.




      RidgeRun Services

      RidgeRun has expertise in offloading processing algorithms using FPGAs, from Image Signal Processing to AI offloading. Our services include:

      • Algorithm Acceleration using FPGAs.
      • Image Signal Processing IP Cores.
      • Linux Device Drivers.
      • Low Power AI Acceleration using FPGAs.
      • Accelerated C++ Applications.

      And it includes much more. Contact us at https://www.ridgerun.com/contact.


      Previous: Architecture Index Next: Bring Up Process