1,189
edits
(→USB) |
|||
Line 587: | Line 587: | ||
==== USB ==== | ==== USB ==== | ||
To flash the filesystem to USB you need to put the filesystem on the USB first | To flash the filesystem to USB you need to put the filesystem on the USB first | ||
1) Insert your USB flash/drive in your PC and check where it was mounted | |||
<pre> | <pre> | ||
mount | mount | ||
/dev/sdb1 on /media/dsoto/EF02-5626 type vfat (rw,nosuid,nodev,uid=1000,gid=1000,shortname=mixed,dmask=0077,utf8=1,showexec,flush,uhelper=udisks2) | /dev/sdb1 on /media/dsoto/EF02-5626 type vfat (rw,nosuid,nodev,uid=1000,gid=1000,shortname=mixed,dmask=0077,utf8=1,showexec,flush,uhelper=udisks2) | ||
</pre> | </pre> | ||
2)Format the USB drive in your PCB | |||
<pre> | <pre> | ||
sudo mkfs.ext4 /dev/sdb1 | sudo mkfs.ext4 /dev/sdb1 | ||
</pre> | </pre> | ||
3)Copy the filesystem to the USB drive | |||
<pre> | <pre> | ||
mkdir $DEVDIR/images/fs | mkdir $DEVDIR/images/fs | ||
Line 603: | Line 603: | ||
sudo cp -a * $DEVDIR/images/fs && sync | sudo cp -a * $DEVDIR/images/fs && sync | ||
</pre> | </pre> | ||
4)Unmount the USB drive and remove it | |||
<pre> | <pre> | ||
umount $DEVDIR/images/fs | umount $DEVDIR/images/fs | ||
</pre> | </pre> | ||
5)Finally connect the USB drive to the Jetson board put the Jetson on recovery mode, flash the board to look for the filesystem on the USB port: | |||
<pre> | <pre> | ||
cd $DEVDIR/TX1/Linux_for_Tegra_tx1/ | cd $DEVDIR/TX1/Linux_for_Tegra_tx1/ |