Compiling Jetson TX1/TX2 source code: Difference between revisions

Compiling Jetson TX1/TX2 source code (view source)

493 bytes added , 22 April 2016

1,189

edits

@@ Line 336: / Line 336: @@
 . '''Recovery mode'''
-To put the board into reset/recovery mode.
+To put the board into force USB Recovery Mode:
-*Power on the carrier board and hold the RECOVERY button.
+<pre>
-*Then press the RESET button
+. Power down the device. If connected, remove the AC adapter from the device. The device must be
+powered OFF, and not in a suspend or sleep state.
+. Connect the Micro-B plug on the USB cable to the Recovery (USB Micro-B) Port on the device and
+the other end to an available USB port on the host PC.
+. Connect the power adapter to the device.
+. With the system powered on:
+. Press and hold the RECOVERY FORCE buon.
+. While depressing the RECOVERY FORCE buon, press and release the RESET buon.
+. Wait 2 seconds and release the RECOVERY FORCE buon
+</pre>
 . To flash the filesystem in the emmc you need to run:
 <pre>