20,290
edits
Getting Started Guide for Jetson TX1: Difference between revisions
Getting Started Guide for Jetson TX1 (view source)
Revision as of 02:32, 7 October 2016
, 7 October 2016no edit summary
mNo edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
=Introduction= | =Introduction= | ||
On this page you are going to find all the necessary information to start from scratch to use the RidgeRun SDK on your Tegra X1 Jetson module. In the following sections we assume that you have already downloaded your RidgeRun Tegra X1 SDK following the steps on [[RidgeRun | On this page you are going to find all the necessary information to start from scratch to use the RidgeRun SDK on your Tegra X1 Jetson module. In the following sections we assume that you have already downloaded your RidgeRun Tegra X1 SDK following the steps on [[RidgeRun Irazu SDK User Guide#Installation|the RidgeRun installation guide]]. | ||
The first section of this guide shows you how to install Jetpack in your computer and how to configure a TFTP and NFS server. Subsequently, the second section contains instructions about how to configure the RidgeRun's SDK to create a SD card with all software components (uboot, kernel and filesystem) needed to boot to Linux Shell in your Jetson Board. Finally some links to gstreamer pipelines are provided. | The first section of this guide shows you how to install Jetpack in your computer and how to configure a TFTP and NFS server. Subsequently, the second section contains instructions about how to configure the RidgeRun's SDK to create a SD card with all software components (uboot, kernel and filesystem) needed to boot to Linux Shell in your Jetson Board. Finally some links to gstreamer pipelines are provided. | ||