214
edits
Getting Started Guide for Jetson TX1: Difference between revisions
Getting Started Guide for Jetson TX1 (view source)
Revision as of 19:01, 6 October 2016
, 6 October 2016→Configuring SDK to deploy firmware to a SD card
| Line 35: | Line 35: | ||
== Setting up your Jetson to boot from SD card == | == Setting up your Jetson to boot from SD card == | ||
== Configuring SDK to deploy | == Configuring SDK to deploy kernel and filesystem to a SD card == | ||
This section describes how to configure the tegrax1-jetson's SDK to deploy all the components (kernel and file system) into a bootable SD card. The RidgeRun SDK support several filesystem types (SD, eMMC and NFS) however in this case we are going to use it on the SD card as well. | |||
1. Open a make config menu | |||
<pre style="background:#d6e4f1"> | |||
make config | |||
</pre> | |||
running make config your SDK is going to download all basic packages needed by the SDK build system. | |||
2. Go to File System Configuration submenu and configure your filesystem as is shown in Fig.1 and Fig.2 | |||
[[Image:tegraX1-jetson-sdk-v_1_0_0-opt-fs.png|thumb|center|722px|tegraX1-jetson-sdk-v_1_0_0-opt-fs.png]] | |||
<div style="text-align: center;">'''Figure 1'''. Main menu File System Configuration option</div> | |||
<br> | |||
[[Image:tegraX1-jetson-sdk-v_1_0_0-fs-menu.png|thumb|center|722px|tegraX1-jetson-sdk-v_1_0_0-fs-menu.png]] | |||
<div style="text-align: center;">'''Figure 2'''. File System Configuration sub menu</div> | |||
3. Configure your file system target as is shown in Fig.3 | |||
[[Image:tegraX1-jetson-sdk-v_1_0_0-fs-target.png|thumb|center|722px|tegraX1-jetson-sdk-v_1_0_0-fs-target.png]] | |||
<div style="text-align: center;">'''Figure 2'''. File system target</div> | |||
<br> 4. Go to Installer Configuration submenu and configure your destination SD device as is shown in Fig.4 | |||
[[Image:tegraX1-jetson-sdk-v_1_0_0-ints-dev-mmc.png|thumb|center|722px|tegraX1-jetson-sdk-v_1_0_0-ints-dev-mmc.png]] | |||
<div style="text-align: center;">'''Figure 3'''. Configure SD device</div> | |||
5. Compile your SDK | |||
<pre style="background:#d6e4f1"> | |||
make | |||
</pre> | |||
== Installing SDK's firmware to a SD card == | == Installing SDK's firmware to a SD card == | ||