1,189
edits
(→Kernel) |
|||
Line 336: | Line 336: | ||
1. '''Recovery mode''' | 1. '''Recovery mode''' | ||
To put the board into | To put the board into force USB Recovery Mode: | ||
<pre> | |||
1. Power down the device. If connected, remove the AC adapter from the device. The device must be | |||
powered OFF, and not in a suspend or sleep state. | |||
2. Connect the Micro-B plug on the USB cable to the Recovery (USB Micro-B) Port on the device and | |||
the other end to an available USB port on the host PC. | |||
3. Connect the power adapter to the device. | |||
4. With the system powered on: | |||
5. Press and hold the RECOVERY FORCE buon. | |||
6. While depressing the RECOVERY FORCE buon, press and release the RESET buon. | |||
7. Wait 2 seconds and release the RECOVERY FORCE buon | |||
</pre> | |||
2. To flash the filesystem in the emmc you need to run: | 2. To flash the filesystem in the emmc you need to run: | ||
<pre> | <pre> |