How to configure and use CAN bus

From RidgeRun Developer Connection

Revision as of 04:36, 20 December 2010 by Tfischer (Talk | contribs)
Jump to:navigation, search

This article explains how to enable the CAN bus using as example the AM35x EVM, but can be applied to other platforms as well.

Contents

Build the SDK with socketcan and ip tools

Working with the CAN buys requires enabling the 'ip' tools from iputils2 package (the 'ip' tool from busybox won't work). The socketcan package is optional and provide you with tools to debug your can bus.

This packages are available from the RidgeRun SDK in the configuration menu.

Enable the kernel driver

In the case of the Category:AM35x platform the configuration is:

Linux Kernel Configuration
     Networking support
        CAN bus subsystem support
           CAN device drivers
               Platform CAN drivers with Netlink support
                 CAN bit-timing calculation
                 TI High End CAN controller (HECC)

Setup the networking rules

Edit your /etc/networking/interfaces on the target filesystem and add the following rules (required to setup the bit-rate of the bus):

auto can0
iface can0 inet manual
	#pre-up ip link set $IFACE type can bitrate 125000 listen-only off
	pre-up /ip link set $IFACE type can bitrate 125000 triple-sampling on
	up /sbin/ifconfig $IFACE up
	down /sbin/ifconfig $IFACE down

References

Navigation
Toolbox