Getting Started Guide for the OMAP35x

From RidgeRun Developer Connection

Jump to:navigation, search


Installation Guide

Setting up serial access to the Linux console

You use the serial port to control u-boot and Linux. The picocom terminal emulator work well for this purpose.

Setting up Picocom - Ubuntu

Partitioning an SD card

You can store the file system on an SD card. To do this, you need to have the right partitions setup on the SD card. These steps will create two partitions, the second one is used to hold the target file system.

Creating a bootable SDcard

Setting up a TFTP server

If you are using the SDK, you can speed downloads to the target hardware by using TFTP. You host PC needs to be configured as a TFTP server for this to work.

Setting Up A Tftp Service

Setting up an NFS server

For application development, it is convenient to use root NFS mount file system for the target hardware. This allows you to rebuild your application on the host and immediately run the application on the target hardware with no interveining steps. You host PC needs to be configured as a NFS server for this to work.

Setting Up A NFS Service

Checking out the binary images

If you simply want to run the pre-built versions of the Linux kernel using the pre-built file system, then please contact

Saving pre-built kernel and file system on target hardware

In order to boot the OMAP35x from an SD you must complete the following steps:

1. First, format an SD Card with 2 partitions; in the first one use a FAT32 format with 32Mb of size and with the boot flag enabled, the second one partition with the rest of the SD Card, called rootfs, must have an EXT3 format as is described in Creating a bootable SDcard

2. Copy the u-boot image, x-loader image (must be called MLO into the SD) and the kernel image located in <PathofYourSDK>/images into the partion named boot:

<PathofYourSDK>/images$ cp bootloader /media/boot/u-boot.bin 		
<PathofYourSDK>/images$ cp x-load.bin.ift /media/boot/MLO
<PathofYourSDK>/images$ cp kernel.uImage /media/boot/uImage

3. Uncompress with sudo privileges the file system into the partition named rootfs.

sudo tar -C /media/rootfs -xjf OMAP35x-fs.tar.bz2

4. Ensure SW4 is set as is described in Section Main Board SW4

5. Once the above steps have been completed, turn on the OMAP35x and press enter to get a U-boot prompt and set the bootargs as follows:

OMAP3_EVM # setenv bootargs 'console=ttyS0,115200n8 rootdelay=2 root=/dev/mmcblk0p2 mem=102M' 
OMAP3_EVM # saveenv

What's Tested and Supported

AUDIO audio test OMAP35x
RS232 USB-RS232 test OMAP35x
Ethernet Ethernet Test OMAP35x
USB port USB Test OMAP35x
GStreamer GStreamer Test OMAP35x