Ethernet Test Spartan 6 LX45T/OMAP L138

From RidgeRun Developer Connection

Revision as of 19:16, 27 August 2010 by Dsoto (Talk | contribs)
Jump to:navigation, search

From u-boot

Using the tftp command used by the RidgeRun SDK installer we tested the Ethernet from u-boot. You have to configure a tftp server on your host.

Using NFS

After the kernel boots and loads fs. The SDK is set to use Network file system it validate the Ethernet after kernel boot

[    2.890000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:00, id=7c0)
[    3.910000] Sending DHCP requests .                                                
[    4.890000] PHY: 1:00 - Link is Up - 100/Full                                      
[    6.890000] ., OK                                                                  
[    6.980000] IP-Config: Got DHCP answer from 10.251.101.3, my address is 10.251.1014
[    6.980000] IP-Config: Complete:
[    6.990000]      device=eth0, addr=10.251.101.64, mask=255.255.255.0, gw=10.251.10,
[    7.000000]      host=10.251.101.64, domain=cr.ridgerun.com, nis-domain=(none),
[    7.000000]      bootserver=10.251.101.3, rootserver=10.251.101.7, rootpath=
[    7.010000] Looking up port of RPC 100003/2 on 10.251.101.7
[    7.030000] Looking up port of RPC 100005/1 on 10.251.101.7
[    7.150000] VFS: Mounted root (nfs filesystem) on device 0:14.
[    7.160000] Freeing init memory: 152K
init started: BusyBox v1.14.2 (2010-07-15 08:18:59 CST)
<pre>
Navigation
Toolbox