1,433
edits
(Created page with "<noinclude> {{JetsonXavierNX/Head|previous=Introduction/Overview|next=Development/Building_the_Kernel_from_Source|keywords=installation,setup,setup the board,boot,booting,gett...") |
No edit summary |
||
Line 1: | Line 1: | ||
<noinclude> | <noinclude> | ||
{{JetsonXavierNX/Head|previous=Introduction/ | {{JetsonXavierNX/Head|previous=Introduction/Developer_Kit|next=Development/Building_the_Kernel_from_Source|keywords=installation,setup,setup the board,boot,booting,getting started|title=Getting Started with NVIDIA Jetson Xavier NX Developer Kit|description=This page provides the steps to getting started with Jetson Xavier NX developer kit}} | ||
</noinclude> | </noinclude> | ||
Line 12: | Line 12: | ||
Once downloaded the image you need to write it to your microSD by following the instructions bellow: | Once downloaded the image you need to write it to your microSD by following the instructions bellow: | ||
1. Insert the microSD card to your computer and identify the corresponding device | 1. Insert the microSD card to your computer and identify the corresponding device: | ||
<pre> | |||
dmesg | tail | awk '$3 == "sd" {print}' | |||
</pre> | |||
2. Flash the downloaded image, change /dev/sdx to your corresponding device | 2. Flash the downloaded image, change /dev/sdx to your corresponding device: | ||
<pre> | <pre> | ||
#Change the path if you download the image to another location | #Change the path if you download the image to another location | ||
Line 22: | Line 25: | ||
3. Remove microSD from your computer | 3. Remove microSD from your computer | ||
<pre> | <pre> | ||
sudo eject /dev/ | sudo eject /dev/sdx | ||
</pre> | </pre> | ||
== Setup the Board == | == Setup the Board == | ||
1. Insert the prepared microSD card into the slot under the Jetson | 1. Insert the prepared microSD card into the slot under the Jetson Xavier NX Module in the developer kit. | ||
2. Connect an | 2. Connect an HDMI display | ||
3. Connect USB keyboard and mouse | 3. Connect USB keyboard and mouse | ||
4. Connect your power supply | 4. Connect your power supply. The Jetson Xavier NX Developer Kit will power on and boot automatically. | ||
== First Boot == | == First Boot == | ||
A green LED next to the Micro-USB connector will light as soon as the developer kit powers on. The Jetson Xavier NX Developer Kit will take you through some initial setup on the first boot time. | |||
{{JetsonNano/Foot|Introduction/ | |||
* Review and accept NVIDIA Jetson software EULA | |||
* Select system language, keyboard layout, and time zone | |||
* Connect to Wireless network | |||
* Create username, password, and computer name | |||
* Log in | |||
After all these steps you should see the Ubuntu 18.04 GUI Desktop. | |||
{{JetsonNano/Foot|Introduction/Developer_Kit|Development/Building_the_Kernel_from_Source}} | |||
</noinclude> | </noinclude> |
edits