Mistral DM37x EVM SDK 2011Q2 Getting Started Guide
From RidgeRun Developer Connection
This guide is oriented to help the new users to configure their Mistral DM37x EVM boards and work with the RidgeRun's SDK 2011Q2.
Using the board's features
This section shows how to use some of the basic features of the board using the RidgeRun's SDK 2011Q2.
Setting the booting mode
RideRun's SDK supports SD card and NAND boot either selected in hardware for each specific board. In the case of the Mistral DM37x EVM board the boot options are selected from the switch SW4 as is shown in the following image:
The correct combination for the selection of each boot mode is described below:
- NAND boot mode
In order to set the NAND boot mode set SW4 switches #2, #4 and #6 to the ON position and all others OFF as is show below:
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | SW7 | SW8 | | | | | | | | | | | OFF | ON | OFF | ON | OFF | ON | OFF | OFF |
- MMC/SD card boot mode
In order to set the SD/MMC card boot mode set SW4 switches #3, #6, #7, #8 to the ON position and all others OFF as is shown below:
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | SW7 | SW8 | | | | | | | | | | | ON | ON | ON | OFF | OFF | ON | OFF | OFF |